Auktionen är avslutad.

Elektronisk Termostat 12 VDC med SPST Flytande Relä, Galvaniskt Skild 125VAC 20A

97 besökare

Auktionen är avslutad

Vinnare: Musicman50
  • Frakt
    • Posten (7 kr)
    Mer info
  • Skick
    Ny
  • Betalning
    • Klarna - Betala med kort, faktura eller via internetbank
    • Paypal
    • Swish
    • Banköverföring
  • Om säljaren

Beskrivning

Elektronisk Termostat, 12 VDC drivspänning. SPST Flytande Relä, Galvaniskt Skild 125VAC 20A.
Kan användas bl.a till temperaturkontrollerad fläkt till Dummy Load och mycket annat.
Omslagstemperaturen ställs enkelt med de 3 knapparna.

Med en enkel "Hidden Code Settings" går det att ställa flera parametrar så som Temperature Correction,
delay Start Time 0-10min, Hysteresis 0.5-15° m.m. Se "How to use" nedan.

Mycket flexibel liten termostat med många användningsområden

Se "How to use" nedan.

Snabb leverans. Skickas normalt mellan 1-2 vardagar.

Lite Specs:
Control Temperature range :-50-110 °
Dimensions: 48.5 * 40mm
Temperature control mode: ON / OFF
Resolution:When temperature is 0.1°, the resolution is -9.9~99.9, other temperature segment is 1°
Control accuracy: 0.1 °
Hysteresis accuracy: 0.1°
Refresh rate: 0.5S
High temperature protection: 0-110°
Supply voltage: DC 12V
Idle current: = 35mA
Relay akive = 65mA

Relay type, SPST:
125 VAC
20A

Temp. Probe:
NTC (10K 0.5%) Waterproof Sensor
PCB Environmental Requirements: -10 ~ +60 ° ,Humidity 20% -85

How to use:
  • Connect the power supply and the load, you can supply to the controller,Is displayed as a measured temperature,Press the SET button, the display flashes the temperature,Press + - to set the desired temperature,After setting press SET to confirm return,The controller automatically performs the relay by setting off!
  • Lights, LED status descriptions:Indicator: Off The relay is switched off, Always indicate the relay is closed.LED: Shows LL is the sensor open, showing HH is out of range, the thermostat will be forced to close the relay, the display --- as high temperature protection.
  • Parameter Function:Long press SET 5 seconds to enter the main menu settings, press the + - toggle P0 ... P8 long press SET or 10 seconds of no key activity confirmed their return to the controller
Code Description
P0 Cooling /Heating C/H Default C
P1 Hysteresis setting 0.5-15 Default 2
P2 Highest setting upper limit 110 Default 110
P3 Lowest setting upper limit -50 Default -50
P4 Temperature correction -7-7 Default 0
P5 Delay start time 0-10 Minutes Default 0
P6 High temperature alarm 0-110 Default OFF
Press + - long time to boot and restore to factory default settings.
Annons
GÅ TILL TRADERA >
×