1/0


Beskrivning
-Drv8825 Stepper Motor Driver för 3D printer
- Helt ny
- leveranstider 2-4 arbetsdagar
- 3st
Product description
? Relative 4988 Features Benefits:
1. the maximum current of 2.5A.
2. up to 32 segments.
3. 4-layer PCB, better heat dissipation.
4. the chip resistance is smaller, less heat, and better heat dissipation.
? Parameters:
1. Size: 1.5mmX2mm (and the same 4988)
2. Can drive currents: 2.5A
3. Segmentation: 1,1 / 2,1 / 4,1 / 8,1 / 16,1 / 32
4. Manufacturing Process: SMT placement machine higher manufacturing, non-manual welding, yield more stable performance
? Suitable for:
1. Need to drive stepper motors.
2. It is to build a 3d printer, cnc, engraving machine and other essential modules.
3. Supported 3d printers have Prusa Mendel, ultimaker, printbot, makerbot like.
4. You can refer back Arduino code, direct drive motor
? DRV8825 features are the following:
1, suitable for driving below 8.2V ~ 45V 2.5A stepping motor;
2, only a simple step and direction control interface;
3, six different stepping modes: full, half, 1 / 4,1 / 8,1 / 16,1 / 32;
4, adjustable potentiometer can adjust the maximum current output, resulting in higher step rate;
5, Automatic current decay mode detection / selection;
6, thermal shutdown circuit, undervoltage lockout, crossover current protection;
7, ground short-circuit protection and load short circuit protection.
- Helt ny
- leveranstider 2-4 arbetsdagar
- 3st
Product description
? Relative 4988 Features Benefits:
1. the maximum current of 2.5A.
2. up to 32 segments.
3. 4-layer PCB, better heat dissipation.
4. the chip resistance is smaller, less heat, and better heat dissipation.
? Parameters:
1. Size: 1.5mmX2mm (and the same 4988)
2. Can drive currents: 2.5A
3. Segmentation: 1,1 / 2,1 / 4,1 / 8,1 / 16,1 / 32
4. Manufacturing Process: SMT placement machine higher manufacturing, non-manual welding, yield more stable performance
? Suitable for:
1. Need to drive stepper motors.
2. It is to build a 3d printer, cnc, engraving machine and other essential modules.
3. Supported 3d printers have Prusa Mendel, ultimaker, printbot, makerbot like.
4. You can refer back Arduino code, direct drive motor
? DRV8825 features are the following:
1, suitable for driving below 8.2V ~ 45V 2.5A stepping motor;
2, only a simple step and direction control interface;
3, six different stepping modes: full, half, 1 / 4,1 / 8,1 / 16,1 / 32;
4, adjustable potentiometer can adjust the maximum current output, resulting in higher step rate;
5, Automatic current decay mode detection / selection;
6, thermal shutdown circuit, undervoltage lockout, crossover current protection;
7, ground short-circuit protection and load short circuit protection.
Mer från samma kampanj
Andra har även tittat på
Du kanske också gillar
3st Drv8825 Stepper Motor Driver för 3D printer
Slutar 27 maj 20:35
95 kr
102 kr med köparskydd.