MSF-Technik Vathauer DTSG 4 Einschub 3×400 V AC Digital Clock Timer Module, Used

MSF-Technik Vathauer DTSG 4 “Einschub” digital timer module for controlling three-phase motors at 3×400 V AC, in good working used condition.Front panel includes LED display, mode/time keys, power switch and a D-sub interface; rear has a pluggable terminal strip with pre-wired leads. Item details - Brand: MSF-Technik Vathauer Antriebstechnik - Series: DTSG 4 - Model: DTSG 4 Einschub (plug-in version) - Ident No.: 0447030160 (as on nameplate) - Type: Digital clock timer / cycle timer for 3-phase asynchronous motors - Supply/output: 3×400 V AC, IP20 protection class - Function: Controls start/stop cycles with freely adjustable run and pause times, intended for conveyor or material-handling drives. - Front interface: - 7-segment LED time display (behind red window) - Green illuminated power rocker switch (I/O) - Two membrane keys labeled Modus/Mode and Stellen/Set for parameter entry (German text) - 9-pin D-sub connector with metal hood for external signals or programming (pinout not confirmed; see manual). - Rear connections: - Pluggable green terminal block with numbered terminals 1–8, currently with short leads and PE wire installed (you may wish to remove/replace). - Mounting: Panel or enclosure mounting using front flange with four mounting holes; passive convection-cooled aluminum housing. Condition - Used, tested and in good working condition as stated. - Aluminum housing shows surface scratches, fingerprints, and marks from previous installation. - Front keypad legends and display window remain readable; rocker switch and connector intact. - Rear terminal block populated with cut leads and a yellow-green protective earth wire; insulation and ferrules appear intact. - No original box, manuals, or additional accessories included. Notes - Suitable as a replacement timer module for existing MSF-Vathauer DTSG 4 systems in conveyor or motor applications. - Buyer should verify wiring diagram, motor power rating, and safety requirements in the original MSF documentation before installation. - Remove or re-terminate existing short leads as needed and observe proper protective earthing and 3×400 V AC wiring practices.